Honda ca95 clutch

NickyRudolph · Post by **NickyRudolph** » Thu Apr 23, 2015 7:51 pm

Replacing the plates on my honda today. It had 5 plates all of the same thickness, so I doubled up on one at the start. Will this be a problem? Also, when putting on that plate with the springs behind it, do I tighten all the way down? How far do i go down. The tighter i go, the more impossible it gets to pull the clutch. Thanks.

VegeKev · Post by **VegeKev** » Tue Apr 28, 2015 7:17 pm

Hey Nick,

Those four bolts (6mm x 20mm) need to be tensioned to 4-5 ftlb

Kev.