Four Wheel Forum

Posted: **Tue Jan 20, 2015 6:11 am**

So, I was going to restore my 150 but it's been put off for so long I don't think it's going to happen.
Now we're going to be moving to the opposite coast and I don't think I'll have the room for it where we're moving.

It was a complete bike before I dismantled it. Everything was there but the chain guard cover. The crank was bad so that was replaced. New pistons and freshly bored cylinders not even installed yet.

Check out this gas tank with zero rust inside it. I was amazed how clean it was when I first bought it.

My question is should I part it out or make it a rolling chassis and try to sell it complete. It's a bare frame right now.

Posted: **Tue Jan 20, 2015 3:09 pm**

No Longer Available

Posted: **Wed Jan 21, 2015 10:59 am**

Spot on chip!

Posted: **Fri Jan 23, 2015 4:54 am**

Thanks for the reply. It would be easy to part it out as everything is already apart. I would rather not use eBay though.

Posted: **Fri Jan 23, 2015 6:14 pm**

I might be interested in the speedo if it is in good working condition...

Posted: **Sat Jan 31, 2015 6:06 pm**

2 right-side logos on the fuel tank - needs a left side logo (should be flying forward)

Posted: **Fri Feb 13, 2015 7:11 am**

Sorry guys haven't been back on here lately.

Well, it looks like we'll be moving March 23rd so I have to get rid of this stuff. Would like to just sell everything all at once.

I'm thinking $400 for everything. It was a complete bike, minus the chain guard. I have brand new pistons, all the gaskets, new tail light/bracket.

I'm not sure if the speedo works since I never ran the bike.

Posted: **Fri Feb 13, 2015 7:08 pm**

No Longer Available

Posted: **Sat Feb 14, 2015 3:29 am**

Sorry. Sold within hours on the ADV site.

Four Wheel Forum

Possible part out

Possible part out