Thanks for all the advise and suggestions!
BTL... that ignition diagram is great... very helpful, thank you.
So I did as you suggested and hooked up the jumper cables to the starter.... it buzzed to life... it works
Also, I beleive you're right on that winding wire, appears to be a factory dead-end wire. So I'll try the newly acquired stator in the build.
Spokes... I know this is a stupid question, but what is the clutch actuator? Do you have a picture or part number so I can look it up?
I'll certainly take the recommendation and burnish/polish any burrs off.
Also, here's that new front sprocket... much nicer than the old one. Amazing how much was worn off and the uneven wear.
At first I thought it wouldn't fit because the center grooves weren't as deep as the original, but it fits like a glove and has clearance for the sprocket plate.
