|
The Honda CA95 / Benly 150 Restoration The little brother to the CA160 in our family of Hondas |
Thread Tools |
#1
|
|||
|
|||
Carb idle air mixture question >>>
The manual states...screw in > Rich; out> lean.
I screwed it in rich until the engine lost a few rpm, then out 1/2 turn. Is this correct? The other option would be to screw out lean until engine loses rpm, then in 1/2 turn or so. Thoughts? Appreciate all! |
#2
|
|||
|
|||
Basically, I adjust idle to whatever I feel is a good idle. I turn out the screw until nearly stall and then screw in until I like the idle. I don't think there is a hard fast rule.
|
#3
|
||||
|
||||
I'd agree with Spokes( who wouldn't). Heck my mixture screw is so loose the idle changes if it sits and vibrates too long.
|
#4
|
|||
|
|||
Spokes: Thx again.
Larzfromarz: Wrap teflon thread sealant tape around the air screw; enough to tighten it up. |