|
The Honda CA95 / Benly 150 Restoration The little brother to the CA160 in our family of Hondas |
Thread Tools |
#1
|
|||
|
|||
Possible part out
So, I was going to restore my 150 but it's been put off for so long I don't think it's going to happen.
Now we're going to be moving to the opposite coast and I don't think I'll have the room for it where we're moving. It was a complete bike before I dismantled it. Everything was there but the chain guard cover. The crank was bad so that was replaced. New pistons and freshly bored cylinders not even installed yet. Check out this gas tank with zero rust inside it. I was amazed how clean it was when I first bought it. My question is should I part it out or make it a rolling chassis and try to sell it complete. It's a bare frame right now. |
#2
|
|||
|
|||
No Longer Available
Last edited by Spokes; 11-16-2015 at 03:38 PM. |
#3
|
||||
|
||||
Spot on chip!
|
#4
|
|||
|
|||
Thanks for the reply. It would be easy to part it out as everything is already apart. I would rather not use eBay though.
|
#5
|
||||
|
||||
I might be interested in the speedo if it is in good working condition...
|
#6
|
||||
|
||||
2 right-side logos on the fuel tank - needs a left side logo (should be flying forward) :-)
|
#7
|
|||
|
|||
Sorry guys haven't been back on here lately.
Well, it looks like we'll be moving March 23rd so I have to get rid of this stuff. Would like to just sell everything all at once. I'm thinking $400 for everything. It was a complete bike, minus the chain guard. I have brand new pistons, all the gaskets, new tail light/bracket. I'm not sure if the speedo works since I never ran the bike. |
#8
|
|||
|
|||
No Longer Available
Last edited by Spokes; 11-16-2015 at 03:38 PM. |
#9
|
|||
|
|||
Sorry. Sold within hours on the ADV site.
|