View Single Post
  #8  
Unread 11-04-2008, 12:55 AM
Smithers's Avatar
Smithers Smithers is offline
Admin
 
Join Date: Feb 2004
Location: San Luis Obispo, CA
Posts: 3,238
Send a message via AIM to Smithers Send a message via Skype™ to Smithers
Default

Ok here we are. Today was a fun time spending a couple hours fitting titanium bolts all over wherever I could. Check out the results here if you haven't seen the new jewelry already: http://www.fourwheelforum.com/index.php?showtopic=255 I also got another nice shot of the rearsets with the new hardware. I've done a lot of adjusting on them and this is where they are going to stay. I got the shift rod installed on the inside which is the best way. I had it like this before but then when I was messing with it again (see a couple posts up) you can see that I had the front mount on the outside... not good. So this is finally the way to have it together.

I REALLY like the shifting action with the shift rod mounted in the holes that you see here. Every shift is perfect and smooth. I can also find neutral without any problems. Before it was king of a pain before I dropped the rear heim mount down to the lower hole.







http://www.fourwheelforum.com/index.php?showtopic=255
Reply With Quote