Thread
:
Splitting the Headlight Enclosure
View Single Post
#
2
12-07-2008, 10:11 PM
Smithers
Admin
Join Date: Feb 2004
Location: San Luis Obispo, CA
Posts: 3,238
It was much easier to start at the top and work my way around the sides and down to the bottom which is the hardest part for sure. Putting the whole thing in the oven might be a good technique but I just grabbed my industrial heatgun, turned on the radio and went to work. It was pretty agonizing. But I conquered.
And the bottom part. As you can see chewed up pretty bad but then you don't see this at all from the outside of the bike so I didn't care. It took a long time. :\
Smithers
View Public Profile
Visit Smithers's homepage!
Find all posts by Smithers