Mine is 490mm from the adjust end to the pin. I get full travel of the arm, just no braking until I pull the arm to where it would bend the rod. If I move it up on the splines it will brake correctly but arm pressure in the hub pulls back on the pedal so that it is extremely high up. This is in the configuration where there is no brake through full movement of the pedal. You can see wit just a little movement the pedal bends the switch spring. I'm wondering now if I have the correct pedal. The pedal connector has a pin going through it with a cotter key. Looks correct per the diagrams. I'll post some pictures in another post from my desktop.
|