Rocketsled
11-17-2013, 06:26 PM
Benly is really running down the homestretch to running again under it's own power...and I'm to a point I've been putting off for a long time: setting the motor up. Valve lash, dwell and advance, timing chain tension, etc.
So. The actual valve adjustment uses a wrench at least two sizes smaller than anything I have...I have a 4mm wrench, but this thing is, like, 2 or 3 mm across.
Where the heck to you get a 2 mm box end wrench?
So. The actual valve adjustment uses a wrench at least two sizes smaller than anything I have...I have a 4mm wrench, but this thing is, like, 2 or 3 mm across.
Where the heck to you get a 2 mm box end wrench?